杨 霞, 张志胜, 郑乾魏, 祖铁红, 淑 英. 超临界CO2萃取南美白对虾虾青素的工艺优化[J]. 农业工程学报, 2013, 29(25): 294-300.
    引用本文: 杨 霞, 张志胜, 郑乾魏, 祖铁红, 淑 英. 超临界CO2萃取南美白对虾虾青素的工艺优化[J]. 农业工程学报, 2013, 29(25): 294-300.
    Yang Xia, Zhang Zhisheng, Zheng Qianwei, Zu Tiehong, Shu Ying. Optimization of supercritical CO2 extraction of astaxanthin from pacific white shrimp (Litopenaeus vannamei) using response surface methodology[J]. Transactions of the Chinese Society of Agricultural Engineering (Transactions of the CSAE), 2013, 29(25): 294-300.
    Citation: Yang Xia, Zhang Zhisheng, Zheng Qianwei, Zu Tiehong, Shu Ying. Optimization of supercritical CO2 extraction of astaxanthin from pacific white shrimp (Litopenaeus vannamei) using response surface methodology[J]. Transactions of the Chinese Society of Agricultural Engineering (Transactions of the CSAE), 2013, 29(25): 294-300.

    超临界CO2萃取南美白对虾虾青素的工艺优化

    Optimization of supercritical CO2 extraction of astaxanthin from pacific white shrimp (Litopenaeus vannamei) using response surface methodology

    • 摘要: 为提高虾青素萃取物得率和虾青素纯度,采用超临界CO2萃取南美白对虾虾头废弃物中的虾青素,皂化后用高效液相色谱对虾青素含量进行测定。单因素试验确定萃取参数对虾青素萃取物得率和虾青素纯度的影响,然后进一步运用响应面法对萃取工艺参数进行优化。结果表明:超临界CO2萃取工艺参数对虾青素萃取物得率影响不显著(P>0.05),但对虾青素纯度影响显著(P<0.05);物料粒径40目,质量含水率9%时,响应面理论优化最佳萃取参数为萃取压力403.95 Pa,萃取温度39.95℃,CO2流量1.16 L/min,虾青素纯度为796.3 mg/g。结合实际应用,验证试验在萃取压力400 Pa,萃取温度40℃,流量1.2 L/min时,虾青素纯度为789.61 mg/g。研究结果可为虾青素的提取和纯化提供参考。

       

      Abstract: In order to improve the extraction yield and content of astaxanthin, supercritical CO2 fluid extraction was used to extract astaxanthin from the head of Pacific White Shrimp, high performance liquid chromatography (HPLC) was adopted to determine the content of astaxanthin after saponification, the influence of extraction parameters on the extraction yield and astaxanthin content was determined by single factor test, then response surface method was employed to optimize technical parameters. The results showed that the influence of extraction parameters on the extraction yield of astaxanthin was not significant(p>0.05),but significant on the astaxanthin content (p<0.05). When the particle size of material was 40 mesh, moisture content was 9%, the theory optimum conditions for extraction astaxanthin with supercritical CO2 extraction were confirmed as follow: pressure 403.95 Pa, extraction temperature 39.95℃, CO2 flow rate 1.16 L/min, under the conditions, the astaxanthin content was 796.3 mg/g. In application, the astaxanthin content in validation test was 789.61 mg/g when the extraction pressure was 400 Pa, the extraction temperature was 40℃ and the CO2 flow rate was 1.2 L/min. The results can provide a reference for extraction and purification of astaxanthin.

       

    /

    返回文章
    返回